Toolsetter PCB Manufacture Part 2

Posted by RJ Gross on July 25, 2013  /   Posted in Uncategorized

After burning through a few copper clads dealing with board warp and vibrations, some times plan #1 does not work out.¬†Fancy fixture plates sometimes can’t compete with good old double sided tape. The fixture now is glorified Beater plate, we loving like to call those plates that take the beating that your table would undoubtedly¬†would take if not protected. Cut 5 successful sets of PCBs switches, ready to assemble the toolsetter bodies.

Carbide_Toolsetter_Beater_Plate

Post a Comment

Your email address will not be published. Required fields are marked *

*

Please type the characters of this captcha image in the input box

Please type the characters of this captcha image in the input box